02420
East Lexington
East Lexington runs along Massachusetts Avenue toward the Arlington line, older two-storey Colonials and bungalows on tighter lots. Renovations here tend to keep the original kitchen footprint, so a wide range or hood is often a close fit between cabinets.
Getting to it
What a call here tends to involve
Access shapes the visit more than the fault does. A range that has to come forward in a galley, a wall oven set into a run of tall cabinets, a built-in behind a panelled door — each one changes what has to come off the van and how long the appointment runs.
Say which you have when you ring, along with the model number, and the visit starts from a much better place.
Services here
Work carried out in East Lexington.
-
Viking Range Repair
Viking's sealed-burner and open-burner gas ranges and the dual-fuel models share a lot of parts and almost none of their failure modes. We work through ignition modules and spark electrodes, gas valves and orifices, oven igniters and bake elements, and the control boards that tie the two halves of a dual-fuel unit together.
- Burner clicking without lighting once the cap is seated back down
- Oven side of a dual-fuel range heating unevenly front to back
- Simmer burner going out whenever the door is closed hard
-
Viking Oven Repair
Single and double wall ovens fail at the control board, the thermostat, or the door — and it is worth knowing which before parts are ordered. We test element and relay behaviour under load, verify actual cavity temperature against the set point, and rebuild hinges and seals on doors that have dropped.
- Display dark or throwing a fault code as soon as power comes back
- Convection element cutting out part way through a bake
- Door glass fogged internally and the hinge visibly sagging
-
Viking Refrigerator Repair
Viking built-in and professional refrigeration uses a compact sealed system behind a cabinet-depth box, so airflow and defrost problems show up long before the compressor does. We handle evaporator and condenser fans, defrost control, thermistors, door alignment after panel work, and sealed-system diagnosis.
- Built-in running warm even with a clean condenser
- Freezer drawer frosting up and jamming on the rails
- Interior fan noise that rises and falls through the day
-
Viking Dishwasher Repair
A Viking dishwasher that will not drain, will not fill or stops mid-cycle is usually telling you about a pump, a float or a door switch rather than the whole machine. We check drain and circulation pumps, spray arm feeds, inlet valves, latches and control boards, and we trace leaks to the actual joint.
- Standing water left in the tub at the end of a full cycle
- Upper spray arm not turning and the top rack coming out soiled
- Cycle stopping partway through with the panel lights flashing
Next
Say what it is doing. We will say what that usually is.
A call costs nothing and the visit is a flat $95, credited against the repair once you approve it.
5 out of 5, across 1133 reviews
-
It would not fill at all. The inlet valve screen was choked with grit from the street work last spring. He cleaned the screen, replaced the valve anyway, and flushed the line before reconnecting.
Waldo N. · East Lexington
-
Standing water was left in the tub at the end of every cycle and it had begun to smell. The drain pump had a shard of glass wedged in the impeller, which he showed me once it was out. He ran three cycles to be sure and dried the floor before he left.
Corinne Z. · East Lexington
-
The door would not shut flush and heat escaped over the top. A stretched spring and a hinge pin worn oval. He replaced both, adjusted the latch, and cleaned out the seal channel while he was at it.
Kwabena P. · East Lexington