About
One manufacturer's platforms, learned properly.
Viking Repair Lexington is an independent repair business working on Viking cooking and kitchen appliances in Lexington and the towns beside it. Ranges, wall ovens, refrigeration and dishwashers — one manufacturer's platforms, learned properly, rather than everything badly.
The method is unglamorous. Take readings before touching a part; know the difference between a component that has failed and an assembly that is reporting a failure; and never fit something because it is the cheapest thing to try next. Most of the repairs that go wrong go wrong at the diagnosis, not at the spanner.
Work is carried out in your kitchen. Nothing leaves the house, and nothing is opened until the price for the work is agreed.
Scope
On the van, and off it.
- Viking gas, dual-fuel and electric ranges, and the ovens inside them
- Single and double built-in wall ovens, including hinge, seal and calibration work
- Built-in and professional refrigeration — fans, defrost, controls and door alignment
- Dishwashers: pumps, spray feeds, inlet valves, latches and leak tracing
- Laundry, waste disposers and small countertop appliances
- Manufacturer programme claims — those go to the manufacturer, not to us
A call, in order
Three stages. None of them optional.
-
The plate, then the complaint
Model and serial off the rating plate — behind the kick panel or inside the oven door frame on most of these — plus what the appliance is doing in your own words. That pairing settles what rides on the van.
-
Readings, in the kitchen
Manifold pressure on gas, spark and flame sense burner by burner, element and sensor resistance under load, cavity temperature against set point through a full preheat. Written down as they are taken.
-
One price, then the work
Parts and labour quoted as a single number and agreed before anything is opened up. If the honest answer is that the appliance is not worth the repair, that is the answer you get.
Next
Ready when the appliance is not.
A flat $95 puts a technician in front of it and produces a written diagnosis.
Money
One fixed figure, then the parts.
The fixed one is the $95 service call: the visit, the readings and the diagnosis, credited in full against the repair once you approve it. Nothing beyond it is quoted down a telephone line, because nothing beyond it honestly can be.
-
Gas, electric or both
A dual-fuel range is two appliances sharing a fascia. Which half failed decides whether the visit is a burner job or an oven job, and those are not the same money.
-
Board or component
A sensor, an igniter or a switch is a component. A control board is an assembly, and it is the difference most people feel on the estimate.
-
Whether it comes forward
Some faults are reachable from the front. Others need the appliance pulled out, and in a narrow galley that is real labour, quoted as labour.
-
Van or order
Igniters, sensors and switches are carried. Boards, hinges and cavity parts for older platforms are ordered, which changes the shape of the visit.
Typical range · parts and labour
| Igniter or burner assembly | $280 – $630 |
|---|---|
| Oven thermostat or heating element | $240 – $800 |
| Control board or touch panel | $380 – $940 |
| Dishwasher pump or control | $270 – $1,300 |
| Refrigeration fan or defrost system | $280 – $680 |
| Compressor or sealed-system repair | $1,100 – $2,450 |
For comparison, replacing the appliance runs $7,030 – $11,360 for the unit alone, before delivery, installation or any gas and electrical work. Worth knowing before agreeing to a large repair.